Agilent Technologies 8590 Series Service Manual page 402

Analyzer Options and Block Diagrams
Option Descriptions
AM/FM Demodulator with Speaker and TV Sync
Trigger Circuitry (Option 102)
For 8591E, 8593E, 8594E, 8595E, and 8596E only. Option 102 enables
you to use amplitude or frequency demodulation and to listen to a
demodulated signal. Option 102 also allows you to TV trigger on the
selected line of a TV video picture frame if both Option 101 and 102 are
installed. The sweep triggering works with interlaced or noninterlaced
displays for the NTSC, PAL, and SECAM formats. Also see Option 301
below.
Option 102 is also available as a retrofit kit (Option R02) after the
purchase of your analyzer, or as a kit part number 5062-6457.
Quasi-Peak Detector and AM/FM Demodulator
With Speaker (Option 103)
For 8591E, 8593E, 8594E, 8595E, and 8596E only. Option 103 enables
you to make automatic or manual quasi-peak measurements, to listen
to a demodulated signal, and to use amplitude or frequency
demodulation.
Option 103 is available as a kit, order 11946A.
Time-Gated Spectrum Analysis (Option 105)
For 8591E, 8593E, 8594E, 8595E, and 8596E only. Option 105 allows
you to selectively measure the spectrum of signals that may overlap in
the frequency domain, but be separated in the time domain. By
adjusting a time gate based on a user-supplied trigger signal, you can
significantly increase the diagnostic capability of your analyzer for
time-interleaved signals.
Option 105 is also available as a retrofit kit (Option R15) after the
purchase of your analyzer, or as a kit 5062-8218.
Option 101 is recommended in addition to Option 105 since it
significantly decreases sweep time and therefore the resolution in the
time domain.
TV Receiver/Video Tester (Option 107)
Option 107 adds non-interfering RF and video measurement capability
to the 8591C cable TV analyzer.
402 Chapter 10