Agilent Technologies 8590 Series Service Manual page 588

Softkey Descriptions
Softkey Descriptions
DROOP Droop
D Droop disables the reset of the peak detector on the A16
ESCRIPTION
processor/video assembly after each analog-to digital
conversion. When an impulse signal is applied, the
decrease, or droop, in the peak-detector output is
visible. The peak detector will charge up to the peak
value of the input signal and then its amplitude will
decrease over time.
Refer to
information about the peak detector.
R S
ELATED OFTKEYS
588
Chapter 4 for additional troubleshooting
CONF TEST
Chapter 13