Agilent Technologies 8590 Series Service Manual page 573

CAL TRK GEN Calibrate Tracking Generator
D
If the correction factors are not stored, they will be lost when the
CAUTION
analyzer is turned off.
R
ELATED
Chapter 13
Note that this function is available for instruments
ESCRIPTION
equipped with Option 010, 50Ω Output Tracking
Generator, and Option 011, 75Ω Output Tracking
Generator, only.
CAL TRK GEN
self-calibration routine.
Be sure to perform the
self-calibration routines before using
Connect the RF OUT from the tracking generator to the
RF INPUT using the CAL cable. Refer to Table 1-4 for
the part number of the 50Ω CAL cable or 75Ω CAL
cable.
When the
STORE
in nonvolatile memory. The correction factors cannot be
viewed.
S
CAL AMPTD
OFTKEYS
CAL FREQ
CAL STORE
initiates the tracking generator
CAL AMPTD
routine is complete, press
CAL TRK GEN
to store the tracking generator correction factors
Softkey Descriptions
Softkey Descriptions
and
CAL FREQ
CAL TRK GEN.
CAL
573