Figure 137: Removing an AS MXC
SEE ALSO
MX480 Application Services Modular Processing Card Description | 162
Installing an MX480 AS MXC
To install an AS MXC (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Align the notches in the connector at the rear of the AS MXC with the notches in the AS MXC slot (slot
1—the bottom slot in the AS MLC), and then slide the AS MXC in until it lodges firmly in the AS MLC.
CAUTION:
components on the bottom of the AS MXC.
Figure 138 on page
384):
Slide the AS MXC straight into the slot to avoid damaging the
383