Tools Required To Install The Mx480 Router Without A Mechanical Lift; Removing Components From The Mx480 Router Before Installing It Without A Lift - Juniper MX480 Hardware Manual

Figure 61: Reinstalling an FPC
SEE ALSO
Preventing Electrostatic Discharge Damage to an MX480 Router | 477

Tools Required to Install the MX480 Router Without a Mechanical Lift

To install the router, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. (11 mm) nut driver
ESD grounding wrist strap
Removing Components from the MX480 Router Before Installing It Without
a Lift
If you cannot use a mechanical lift to install the router (the preferred method), you can install it manually.
To make the router light enough to install manually, you first remove most components from the chassis.
The procedures for removing components from the chassis are for initial installation only, and assume that
M X4 80
237