BayStream 7.3 Documentation Change Notice
Configuring and Managing the File System
You can use the Technician Interface and Site Manager to configure a VFS.
Using the Technician Interface
Perform the following steps:
Use the Technician Interface set command to create a VFS volume for a
1.
specific slot.
volume in Slot 1.
Use the set command to specify the size of the volume.
2.
example of a set command that sets the file size in Slot 1 to 500000 bytes.
Figure 1.
Creating a VFS Volume
TI set command
[4:1] $ set wfFrSwExtFileSysEntry.1.1 1
Figure 2.
Setting the Size of a VFS Volume
TI set command
[4:1] $ set wfFrSwExtFileSysEntry.3.1 500000
Use the Technician Interface commands shown in
volume.
6
Figure 1
shows an example of a set command that creates a VFS
NVFS/DRAM file
system MIB entry
Attribute identifier (3=wfFrSwExtFileSysSize)
NVFS/DRAM file
system MIB entry
BayStream Multiservice Software Version 7.3
Attribute identifier (1=wfFrSwExtFileSysDelete)
Slot number
Slot number
Figure 2
shows an
Value (1=create)
BYS0089A
Value (memory
in bytes)
BYS0090A
Table 3
to manage the VFS
115385-D Rev 01