Cabinets; Removing The Adjustable Center-Mounting Brackets For M320 Four-Post Racks Or Cabinets - Juniper M320 Hardware Manual

M320 Router Hardware Guide
Installing the Large Mounting Shelf for M320 Four-Post Racks or Cabinets
Installing the Small Mounting Shelf for M320 Four-Post Racks or Cabinets

Removing the Adjustable Center-Mounting Brackets for M320 Four-Post Racks or Cabinets

58
To install the large mounting shelf:
On the front of each front rack rail, partially insert a mounting screw into the lowest
1.
hole.
Install the large shelf on the front rack rails. Rest the bottom slot of each ear on a
2.
mounting screw.
Partially insert a mounting screw into the top hole in each ear of the large shelf.
3.
Tighten all the screws completely.
4.
The router is shipped with each spacer bar attached to the rear of each front-mounting
5.
flange. Remove each spacer bar by removing the seven screws that fasten the spacer
bar to the front-mounting flange.
Place one of the spacer bars over an ear of the installed large shelf. Position the notch
6.
in the rear of the spacer bar so the upper part of the bar is flush with the rack rail and
the lower part is flush with the ear of the shelf.
Insert a mounting screw into each of the nonthreaded holes in the recesses of the
7.
spacer bar to secure the spacer bar.
Repeat Steps 6 and 7 for the other spacer bar.
8.
Tighten all the screws completely.
9.
On the back of each rear rack rail, partially insert a mounting screw into the lowest
1.
hole.
Install the small shelf on the back rack rails. Rest the bottom slot of each ear on a
2.
mounting screw. The small shelf installs on the back of the rear rails, extending toward
the center of the rack. The bottom of the small shelf should align with the bottom of
the large shelf.
Partially insert screws into the open holes in the ears of the small shelf.
3.
Tighten all the screws completely.
4.
To remove the adjustable center-mounting brackets:
Loosen the three screws at the top and bottom of each bracket (see Figure 27 on
1.
page 59).
Remove the center-mounting bracket.
2.
Copyright © 2010, Juniper Networks, Inc.