Cabinets; Removing The Adjustable Center-Mounting Brackets For M320 Four-Post; Racks Or Cabinets; Figure 33: Installing The Mounting Hardware For A Four-Post Rack Or Cabinet - Juniper M320 Hardware Manual

Installing the Small Mounting Shelf for M320 Four-Post Racks or Cabinets
Removing the Adjustable Center-Mounting Brackets for M320 Four-Post Racks or Cabinets
Copyright © 2015, Juniper Networks, Inc.
Figure 33: Installing the Mounting Hardware for a Four-Post Rack or
Cabinet
On the back of each rear rack rail, partially insert a mounting screw into the lowest
1.
hole.
Install the small shelf on the back rack rails. Rest the bottom slot of each flange on a
2.
mounting screw. The small shelf installs on the back of the rear rails, extending toward
the center of the rack. The bottom of the small shelf should align with the bottom of
the large shelf.
Partially insert screws into the open holes in the flanges of the small shelf.
3.
Tighten all the screws completely.
4.
Two adjustable center-mounting brackets attached to the center of the chassis (in the
mounting holes closest to the rear of the chassis). but are needed only for center-mounting
in an open-frame rack. Before installing the M320 router in a four-post rack or cabinet,
you must remove the adjustable center-mounting brackets.
Chapter 16: Installing the Mounting Hardware
129