Replacing The Right Flange Shaft Gasket Ring (On An Installed Gearbox) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
Gearbox 0AF - Edition 09.2013
1.2.2 Install
– Drive the new seal ring in up to the stop, do not twist the seal
ring.
– Fill half the space between the sealing lip and dust lip with
sealing grease - G 052 128 A1- .
– Insert the flange shaft.
– Secure the flange shaft with the conical screw and tighten with
tightening torque.
– Bolt drive shaft to flange shaft ⇒ Chassis; Rep. gr. 40 .
– Check gear oil level ⇒ page 127
– Install the front left wheelhouse liner ⇒ Body Work; Rep. gr.
66 .
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
– Install wheel ⇒ Chassis; Rep. gr. 44 .
Tightening torque
Flange shaft on gearbox (conical screw)
1.3 Replacing the right flange shaft gasket
ring (on an installed gearbox)
Special tools and workshop equipment required
♦ Inertia extractor - MP9-501-
♦ Extractor - MP3-419/37-
♦ Drive bushing - MP3-489 (3158)-
♦ Sealing grease - G 052 128 A1-
1.3.1 Removing
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Turn steering to full right lock.
– If applicable remove protection plate for drive shaft from the
engine -arrows-.
– Unscrew drive shaft from flange shaft ⇒ Chassis; Rep. gr.
40 .
– Tie up the drive shaft as far as possible. Avoid damaging the
paintwork on the drive shaft during this operation.
– Position the catch pan under the gearbox.
170
Rep. gr.39 - Final drive - differential
.
⇒ page 172