Table of Contents
Advertisement
36
Chapter 3 Hardware installation
4
Plug the other end of the telephone cable into the WAN port.
Note: To use the ADSL line for both ADSL and regular voice communication, you
must install a splitter filter, which is provided by your service provider.
To connect the BCM50e or BCM50be to the WAN
1
Use the Integrated Router Web GUI to configure the router card on the BCM50e or BCM50be
main units. For more information about how to configure the router, see the BCM50e
Integrated Router Configuration Guide.
2
Connect one end of a standard Ethernet cable to your WAN edge device (for example, an
external ADSL modem or cable modem).
Refer to the documentation for you WAN edge device for proper setup and configuration of
the device.
3
Plug the other end of the Ethernet cable into the WAN port.
Telephone installation
The BCM50 system supports many types of telephony devices (telephones). For more information
about the supported telephones, see the Telephony Device Installation Guide (NN40020-309).
For more information about installing telephones, see the chapter "Installing telephones and
peripherals" in the Installation and Maintenance Guide.
To install telephones
1
Open the box for each telephone, and verify that you have the following components:
•
telephone set
•
power supply and power-supply cable
•
telephone cable
•
installation instructions
2
Visually inspect the components for any damage.
3
Install the telephones as shown in the included installation instructions.
4
Label the telephone with customer-supplied information. Note the location, wall-jack
identifier, and phone number for punch downs and BCM50 software commissioning.
NN40020-308
2 minutes
9 minutes/telephone
Advertisement
Table of Contents
