Replacing The Srx5400 Services Gateway Scb; Removing The Srx5400 Services Gateway Scb - Juniper SRX5400 Hardware Manual

Replacing the SRX5400 Services Gateway SCB

Before replacing the SCB, read the guidelines in
SCB Ejectors" on page 247. To replace the SCB, perform the following procedures:
NOTE: The procedure to replace an SCB applies to the SRX5K-SCB, SRX5K-SCBE, and
SRX5K-SCB3.

Removing the SRX5400 Services Gateway SCB | 248

1.
Installing an SRX5400 Services Gateway SCB | 249
2.
Removing the SRX5400 Services Gateway SCB
To remove the SCB (see
NOTE: The SCB and Routing Engine are removed as a unit. You can also remove the Routing
Engine separately.
CAUTION:
handles properly to avoid damage to the equipment.
1. If you are removing an SCB from a chassis cluster, deactivate the fabric interfaces from any of the
nodes.
NOTE: The fabric interfaces should be deactivated to avoid failures in the chassis cluster.
user@host# deactivate interfaces fab0
user@host# deactivate interfaces fab1
user@host# commit
2. Power off the services gateway using the command request system power-off.
user@host# request system power-off
"Operating and Positioning the SRX5400 Services Gateway
Figure 106 on page 249):
Before removing the SCB, ensure that you know how to operate the ejector
248