Fujitsu F2MC-8L MB89620 Series Hardware Manual page 5

READING THIS MANUAL
n Page Layout
In this manual, an entire section is presented on a single page or spread whenever possible.
The reader can thus view a section without having to flip pages.
The content of each section is summarized immediately below the title. You can obtain a rough
overview of this product by reading through these summaries.
Also, higher level section headings are given in lower sections so that you can know to which
section the text you are currently reading belongs.
n Finding information
In addition to the standard table of contents and index, the following methods are available to
find information in a particular section when required.
l Register index
Information can be looked up in the register index by register name, by bit name, and by their
respective abbreviations.
Sub-heading index
l
The sub-headings in each section (lines that start with n) are collected together in the sub-
heading index. The sub-heading index provides a means of looking up information at a finer
level of detail than the table of contents.
n Naming Conventions for Register Name and Pin Name
Examples for description of register name and bit name
l
By writing "1" to the sleep bit (STBC: SLP) in the standby control register...
Disable the interrupt request output ( TBTC: TBIE = "0") from the timebase timer.
Interrupt is accepted if the interrupt is enabled ( CCR: I = "1").
Notations for shared pins
l
P25/SCK pin
The terminal contain the common pins which are programmably switched for different purposes.
The shared pins are described with each function name delimited by "/ ".
Bit name
Register name abbreviation
Register name abbreviation
Register name abbreviation
Bit name abbreviation
Current status
Bit name abbreviation
Set data
Bit name abbreviation
Register name
MB89620 series