Table of Contents
Advertisement
Adjusting the Self-Propel
Drive
For Self-Propel-Drive Models Only
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1.
Turn the adjustment nut counterclockwise to
loosen the cable adjustments
Figure 44
1. Handle (left side)
2. Adjustment nut
3. Self-propel-drive cables
2.
Adjust the tension on the cables
pulling them back or pushing them forward and
holding that position.
Note:
Push the cables toward the engine to
increase the traction; pull the cables away from
the engine to decrease the traction.
3.
Turn the adjustment nut clockwise to tighten the
cable adjustments.
Note:
Tighten the nut firmly with a socket or
wrench.
(Figure
44).
g273506
4. Turn the nut clockwise to
tighten the adjustment.
5. Turn the nut
counterclockwise to
loosen the adjustment.
(Figure
44) by
Storage
Storage Safety
Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
General Information
Store the machine in a cool, clean, dry place. Cover
the machine to keep it clean and protected.
1.
Perform the recommended annual maintenance
procedures; refer to
2.
Clean under the machine; refer to
under the Machine (page
3.
Remove chaff, dirt, and grime from the external
parts of the engine, the shrouding, and the top
of the machine.
4.
Check the condition of the blades; refer to
Servicing the Blades (page
5.
Service the air filter; refer to
Filter (page
22).
6.
Tighten all nuts, bolts, and screws.
7.
Touch up all rusted or chipped paint surfaces
with paint available from an Authorized Service
Dealer.
Preparing the Fuel System
On the last refueling of the year, add fuel stabilizer
to the fuel as directed by the engine manufacturer.
Empty the fuel tank when mowing the last time before
storing the machine.
1.
Run the machine until the engine shuts off from
running out of fuel.
2.
Start the engine again.
3.
Allow the engine to run until it shuts off.
When you can no longer start the engine, it is
sufficiently dry.
32
Maintenance (page
21).
Cleaning
20).
26).
Servicing the Air
Advertisement
Table of Contents
