Setting Passwords For The Administrator And Temporary - Nortel 1000 Installation And Commissioning Manual

Connectivity and power requirements
Each Nortel IP Phone requires:
• a dedicated 10BaseT or 100BaseT or 10/100BaseT Ethernet interface
• a small desktop hub or switch if sharing an existing desktop Ethernet
connection with a PC.
• a local power supply appropriate for the voltage in the area or a Power
over LAN unit. (The Nortel IP Phone 2002 comes with a built-in 3-port
switch and is ready for LAN powering.)
Installation and configuration procedures
This chapter contains the following procedures:
• Procedure 93: "Configuring VoIP bandwidth management zones using
the CLI" on
• Procedure 94: "Configuring virtual superloops" on
• Procedure 95: "Configuring the IP Phones" on
• Procedure 96: "Setting passwords for the administrator and temporary
IP Telephone Installer" on
• Procedure 97: "Installing Nortel IP Phone hardware components" on
page 417
• Procedure 98: "Entering IP Telephone boot parameters using manual
configuration" on
• Procedure 99: "Entering Nortel IP Phone boot parameters using full
DHCP parameters" on
• Procedure 100: "Entering boot parameters using partial DHCP
parameters" on
• Procedure 101: "Using Set-Based Installation" on
• Procedure 102: "Configuring the IP Softphone 2050" on
• Procedure 103: "Installing the USB Headset Kit" on
• Procedure 104: "Installing the IP Softphone 2050 on your PC" on
page 434
Installing and configuring Nortel IP Phones
page 406
page 414
page 422
page 425
page 427
Communication Server 1000E
Page 405 of 466
page 408
page 409
page 430
page 433
page 434
Installation and Commissioning