Introduction - Nortel 1000 Installation And Commissioning Manual

Page 392 of 466

Introduction

NN43041-310 Standard 01.11
Installing and configuring Nortel IP Phones
For detailed information on the various telephones supported on the
CS 1000E system, refer to Telephones and Consoles: Description,
Installation, and Operation (NN43001-567) and IP Phones: Description,
Installation, and Operation (NN43001-368).
The following Nortel IP Phones can be installed on a CS 1000E system:
• Nortel IP Phone 2001, Nortel IP Phone 2002, Nortel IP Phone 2004 and
Nortel IP Phone 2007
• Nortel IP Softphone 2050
• Nortel IP Audio Conference Phone 2033
• Nortel IP Phone 1120E, Nortel IP Phone 1140E and Nortel IP Phone
1150E
• Nortel IP Phone 1110
• Expansion Module for IP Phone 1100 Series
• WLAN Handsets 2210/2211/2212
• MVC 2050
The system must be configured before the Nortel IP Phones can be installed.
The configuration includes:
• The Nortel IP Phone TN blocks must be defined on the Call Server (See
"Configuring VoIP bandwidth management zones" on
"Using Set-Based Installation" on
• The IP Phones are assigned to an IP telephony node, and use the IP
telephony node properties defined using Element Manager (see
"Configuring an IP telephony node" on
• The IP Phones require local boot parameter configuration (see
"Configuring the Nortel IP Phone boot parameters" on
October 2008
page 430).
page 361).
page 406 or
page 421).