Nortel 1000 Installation And Commissioning Manual page 51

The TTY Settings are:
• Baud Rate: 9600
• Data bit: 8
• Stop bit: 1
• Parity: None
• Flow Control: None
CP PM Call Server Switch Settings
The CP PM Call Server switch S5 must be set to position 1 to indicate that a
CF card is used for the FMD.
The CP-PM Signaling Server switch S5 must be set to position 2 to indicate
that a hard disk is used for the FMD.
CP PM Call Server software
The CP PM Call Server software features the following enhancements for
CS 1000 Release 5.0:
• software is large-system based
• uses the same machine type (711) as CP PII and CP PIV
• new system type (4021)
• new High Availability package (410)
• new menus for setting the Side, Loop and Shelf information. The Loop
and Shelf refer to the IPMG Loop and Shelf where the CP PM CS is
located.
Communication Server 1000E
System components
Installation and Commissioning
Page 51 of 466