Nortel 1000 Installation And Commissioning Manual page 419

Installing and configuring Nortel IP Phones
2 Connect one end of the CAT5 line cable to the Ethernet jack at the back
of the telephone. See Figure 176 on
3 Connect the other end into the IP voice network (Ethernet), using an
RJ-45 connector. See Figure 177 on
WARNING
Do not plug the Nortel IP Phone into an ISDN
connection. Severe damage can result. Consult the
system administrator to ensure that the telephone is
being plugged in to a 10/100BaseT Ethernet jack.
4 Power the Nortel IP Phone with one of the following methods:
a. Using a 16V AC power adaptor, plug the AC power transformer into
the nearest power outlet. Check the Nortel IP Phone User Guide for
country-specific parameters.
b. Using a Power over LAN unit, connect the Power over LAN unit as
shown in Figure 177 on
5 Secure the telephone footstand to the base of the telephone. Use the
angle adjustment grip on the top rear of the telephone to adjust the
position.
Communication Server 1000E
page 418.
page 420.
page 420.
Installation and Commissioning
Page 419 of 466