Basic system telephony configuration
Contents
Introduction
Basic system configuration
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Basic system configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TN assignment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TN assignment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter shows overlay (LD) sequences required to configure the system
with basic telephony features. Your Planning and Engineering group provides
the details needed to configure basic telephony.
Note: The Command Line Interface (CLI) must be used for some
configuration (for example, LD 10 and LD 11) before Element Manager
can be used to further configure basic telephony.
This chapter contains Procedure 110: "Configuring the basic system" on
page
458.
Programming the CS 1000E system requires loading different overlay
programs and using each one to enter a specific type of information.
Communication Server 1000E
Page 457 of 466
Installation and Commissioning
457
457
462
462