Introduction - Nortel 1000 Installation And Commissioning Manual

Page 152 of 466

Introduction

NN43041-310 Standard 01.11
Configuring the CS 1000E CP PM Call Server
The CS 1000E system requires the configuration of an IP telephony node.
The configuration data is stored in the BOOTP.TAB and CONFIG.INI files
on the CS 1000E. Copies of both files are maintained on each node
component (Signaling Server and Media Card).
The preconfigured IP telephony configuration files from the leader Signaling
Server must be imported. These files are saved on the CS 1000E as:
• c:/u/db/node/nodex.cfg where x is the node number
• c:/u/db/node/nodex.btp where x is the node number
Do not attempt to alter the configuration files either manually or with
OTM's ITG or IP Phone management. Use Element Manager only.
The node database files are backed up along with the customer database using
the LD 43 EDD command.
This chapter contains the following procedures:
• Procedure 30: "Configuring login IDs and passwords" on
• Procedure 31: "Enabling the multi-user option" on
• Procedure 32: "Configuring pseudo-terminals (PTYs)" on
• Procedure 33: "Checking PTY status" on
• Procedure 34: "Configuring MG 1000E Bandwidth Management Zone"
on page 161
• Procedure 35: "Launching Element Manager" on
• Procedure 36: "Importing an existing node" on
• Procedure 37: "Performing a datadump using Element Manager"
on page 170
October 2008
IMPORTANT!
page 159
page 153
page 156
page 157
page 166
page 168