Configuring A Transparent Rlogin Port - Nortel 1000 Installation And Commissioning Manual

9 Check port configuration. Enter the command:
LIST PORT xx
LIST PORT xx ALTERNATE CHARA
Where:
xx = port number
Configuring a transparent rlogin port with sample data
Sample data has been incorporated into Procedure 57. This configuration
shows that a device connected to MRV Port 2 will rlogin 47.11.166.76
through pty 10.
Procedure 57

Configuring a transparent rlogin port

1 Enable keepalive timer 1 for the port. Enter the command:
DEFINE PORT 2 IP TCP KEEPALIVE TIMER 1
2 Enable a dedicated service using rlogin. Enter the command:
DEFINE PORT 2 RLOGIN DEDICATED SERVICE 47.11.166.76
3 Enable the port to be accessible only by local command and from a serial
connection only. Enter the command:
DEFINE PORT 2 ACCESS LOCAL
4 Enable the In-Reach Element Manager to complete a ZMODEM transfer
using the rlogin feature. Enter the command:
DEFINE PORT 2 RLOGIN TRANSPARENT MODE ENABLED
5 Enable autoconnect for the port. Enter the command:
DEFINE PORT 2 AUTOCONNECT ENABLED
6 Enable autodedicate for the port. Enter the command:
DEFINE PORT 2 AUTODEDICATED ENABLED
Connecting an IR-8020M-101 Terminal Server
End of Procedure
Communication Server 1000E
Page 261 of 466
Installation and Commissioning