Entering Basic System Configuration Parameters - Nortel 1000 Installation And Commissioning Manual

Entering basic system parameters
Figure 91
Install Tool banner screen
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
#####
#########
########`` `#############
########
#######`
#######
#######
####### #####`
`#########`
#######`
`#######
##########
##``##########
## `########################
`# `########################
###########################``
`````````
Please press <CR> when ready ...
– Primary and Alternate NRS IP addresses for this networked
system. Refer to IP Peer Networking: Installation and
Commissioning (NN43001-313)
– NRS role, if applicable. Refer to IP Peer Networking:
Installation and Commissioning (NN43001-313)
Procedure 44

Entering basic system configuration parameters

1 Press the RST button on the faceplate of the CP PM Signaling Server.
This cold-reboots the Signaling Server and triggers the Install Tool on the
hard drive (see Figure 91)
########
`` `#############
######```####
######``
#####``
#####'
`###`
````####````
Communication Server 1000E
Installing a Signaling Server
`###
####
#### Communication Server 1000 Software
####`
##### Copyright 2002 – 2006
#
<CR>
NORTEL NETWORKS
Installation and Commissioning
Page 217 of 466