Installing and cross-connecting
an external alarm from a PFTU
Contents
Introduction
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing an alarm using an alarm port assigned in LD 15. . . . . . . . . .
Installing an alarm through QUA6 PFTU connections. . . . . . . . . . . . .
This chapter describes the procedures for connecting an external alarm to the
CS 1000E system.
This chapter contains the following procedure: Procedure 109: "Installing an
alarm using an alarm port assigned in LD 15" on
The following are the two methods of connecting an external alarm to the
CS 1000E system:
•
through an alarm port assigned in software
•
through contacts in a QUA6 Power Failure Transfer Unit (PFTU)
Communication Server 1000E
Page 451 of 466
page 452
Installation and Commissioning
451
452
453