Configuring An Rlogin Port For Various Applications - Nortel 1000 Installation And Commissioning Manual

Configuring an rlogin port for various applications

Connecting an MRV LX8020S-102AC-R Terminal Server
xxx.xx.x.xx = Terminal Server IP Address
xxxx = telnet port (for port 1 to 20)
Note: The value of the target telnet port, xxxx, is determined using the
following formula:
TELNET PORT = 2 000 + (port number xx × 100)
For example, if the telnet port is 1, then:
TELNET PORT = 2 000 + (1 x 100)
If the Terminal Server IP Address is 47.11.244.101 and the telnet port is
1, then TELNET command line is:
telnet 47.11.244.101 2100
Example:
telnet 47.11.244.101 (telnet to virtual management port)
The CS 1000E system uses Pseudo TTY (PTY) ports as TTY ports. All serial
applications, such as CDR and Traffic, can be implemented through PTY
ports. PTY ports are configured in LD 17. An external device, such as a
printer, can access a Call Server PTY port through the Terminal Server by
using a remote login (rlogin) session. Using
Procedure 63 to configure a transparent rlogin port.
Procedure 63
Configuring an rlogin port for various applications
1 Enable TCP keep alive timer.
TCP Keepalive feature allows to change polling intervals, number
retries, etc.The TCP keep alive timer is mainly required to check if the
link is up.
This procedure explains how to modify the sysctl.conf file, which
contains the TCP Keepalive settings.
2 To modify the sysctl.conf file:
Communication Server 1000E
= 2 000 + (100)
= = 2100
End of Procedure
HyperTerminal,
Page 273 of 466
follow
Installation and Commissioning