Configuring A Terminal And Sdi Ports - Nortel 1000 Installation And Commissioning Manual

Configuring a terminal and SDI ports

Contents
Introduction
This section contains information on the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Setting the TTY terminal port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Traditional terminal SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . .
CS 1000E CP PM Call Server COM Port connections. . . . . . . . . . . . .
MG 1000E SDI connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Controlling the baud rate. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BayStack 470 SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BayStack 470 SDI connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Media Card SDI connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
In the CS 1000E system, each component (CP PM Call Server, MG 1000E,
Signaling Server, and Baystack switch) has a Serial Data Interface (SDI) port
to be used for software installation and maintenance access. The SDI port can
be accessed by running a Telnet session through the Terminal Server locally
or remotely. See "Configuring a Terminal Server" on
Server Setup. The SDI port can also be accessed by a local terminal through
the SDI connection.
Communication Server 1000E
Page 279 of 466
page 253 for Terminal
Installation and Commissioning
279
280
280
281
282
283
285
285
285