Page 204 of 466
Installing a Signaling Server
Figure 76
Signaling Server role selection
CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)
=====================================================================
Note: This step will over-write all existing configuration parameters
on this Signaling Server.
Please select the role of this Signaling Server.
If this Signaling Server will be a Leader then its data networking
and IP Telephony parameters must be entered now. (This will pre-
configure the IP Telephony node files.)
If this Signaling Server will be a Follower then its data networking
and IP Telephony parameters must be configured through Element
Manager later.
Please enter:
<CR> -> <a> - Set this Signaling Server as a Leader.
<b> - Set this Signaling Server as a Follower.
<q> - Quit.
Enter Choice>
10 Configure the Signaling Server as Leader or Follower. See Figure 76 on
NN43041-310
Standard 01.11
page
204.
•
If there is already a Leader Signaling Server in the IP Telephony
node, enter b at the prompt to set this Signaling Server as Follower.
The Follower Signaling Server configuration screen appears
(Figure 77 on
page
October 2008
205). Go to step 10 on
page
224.