Universal Trunk Card Connections - Nortel 1000 Installation And Commissioning Manual

Universal Trunk card connections

Installing and cross-connecting a trunk card
Note: See "Installing and cross-connecting a Power Fail Transfer Unit"
on page 437 for connecting trunks with the PFTU.
The Universal Trunk card (NT8D14) provides eight Analog trunks that can
function in the modes identified in Table 24. Refer to Table 25 on
for the connections to the Universal trunk at the cross-connect terminal.
Table 24
NT8D14 Universal Trunk card – modes and option settings
Modes
Central (CO)
2-way TIE trunk (loop Dial Repeat)
2-way TIE trunk (Outgoing Incoming
Dial)
Recorded Announcement (RAN)
Paging trunk
Japan CO/DID operation
DID operation
Loop length>2000 ohms
DID operation
Loop length <2000 ohms
Note 1: OFF indicates that no strap is present.
Note 2: J1 and J2 locations apply to all eight trunks.
Communication Server 1000E
End of Procedure
Location
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
Installation and Commissioning
Page 293 of 466
page 294
Jumper strap
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF