Nortel 1000 Installation And Commissioning Manual page 74

Page 74 of 466 System components
NN43041-310 Standard 01.11
The Terminal Server is configured to automatically log in to the active Core
CP PM Call Server upon start-up. It always connects to the Active CPU IP
address.
The CS 1000E can configure up to 16 serial ports for applications within the
configuration Data Block. Ports can be configured by using:
• login userid of "PTYnn" – TTY ports are specified where nn is the PTY
port number configured for a particular TTY within LD 17. If a "PTYnn"
userid is specified and that port is busy because of another login, an error
message will be produced (on the maintenance consoles, in the report
log, or as SNMP alarms).
• no userid or the OTM userid – the highest available PTY port number is
selected
The Terminal Server has the following attributes:
• support "rlogin" protocol on local access mode
• support transparent, or binary mode, on "rlogin" connection
• support port speed up to 115kbps
• support auto rlogin connection and auto-retry after being disconnected
• support BOOTP
• support DHCP
• rack mounted to a 19-inch rack
• provide configurable username for each port
Table 8
MRV IR-8020M Terminal Server profile (Part 1 of 2)
Property
Product Code
Height
October 2008
Description
NTVW00AB
• 1 U (1 U = 1 3/4 inch or 4.4 cm)