Telnet Cs 1000E Com Port From A Pc - Nortel 1000 Installation And Commissioning Manual

Telnet CS 1000E COM port from a PC

Connecting an IR-8020M-101 Terminal Server
Connect port xx (xx = 1 - 19) of the Terminal Server to COM1 port of the
CS 1000E Call Server.
Follow Procedure 55 to establish access to a Call Server from a PC through
telnet Terminal Server. Use the same port number for each procedure step.
Procedure 55
Accessing a CS 1000E from a PC through telnet Terminal Server
1 Disable IP TCP Keepalive Timer so that the telnet session is always on
and LAN traffic is reduced. Enter:
DEFINE PORT xx IP TCP KEEPALIVE TIMER 0
Where: xx = 1-19
Note: Do not change the configuration for the default console (port 20).
2 Specify the character to be transferred for <CR> in telnet. Enter:
define port xx TELNET NEWLINE FILTERING CR
3 Define the port baud rate to equal the baud rate of the CS 1000E COM
port. Enter:
define port xx speed [BAUDRATE]
Where: xx = Port number from 1-19 and BAUDRATE = the baud rate of
the connected Call Server COM port.
4 Logout. Enter:
logout port xx
5 Check the configuration. Enter:
list port xx alternate chara
list port xx telnet chara
6 Run telnet on the PC.
a. In Windows:
Start > Run
Communication Server 1000E
Page 257 of 466
Installation and Commissioning