Replacing The Mx480 Cable Management Brackets - Juniper MX480 Hardware Manual

Replacing the MX480 Cable Management Brackets

To remove the cable management brackets (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Loosen the captive screws on either side of the chassis.
3. Remove the cable management brackets.
To install the cable management brackets (see
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Position the on the front sides of the chassis.
3. Insert the tabs into the slots.
4. Tighten the screws completely.
Figure 89: Removing the Cable Management Brackets
Slot
Tab
Figure 89 on page 286):
Figure 89 on page 286):
Screws
286