Juniper MX480 Hardware Manual page 52

WARNING:
and not for any other use.
WARNING:
Translation from Japanese: The attached power cable is only for this product. Do not
use the cable for another product.
NOTE: In North America, AC power cords must not exceed 4.5 m (approximately 14.75 ft) in
length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and
210-52, and Canadian Electrical Code (CEC) Section 4-010(3). You can order AC power cords
that are in compliance.
WARNING:
location. It has a separate protective earthing terminal (sized for UNC 1/4-20 ground
lugs) provided on the chassis in addition to the grounding pin of the power supply cord.
This separate protective earthing terminal must be permanently connected to earth.
CAUTION:
drape where people could trip on them.
SEE ALSO
Connecting Power to an AC-Powered MX480 Router with Normal-Capacity Power Supplies | 254
Replacing an MX480 AC Power Supply Cord | 395
The AC power cord for the router is intended for use with the router only
The router is pluggable type A equipment installed in a restricted-access
Power cords and cables must not block access to device components or
53