Powering On A Dc-Powered Mx480 Router With Normal Capacity Power Supplies - Juniper MX480 Hardware Manual

8. Route the power cables along the cable restraint toward the left or right corner of the chassis. If needed,
thread plastic cable ties, which you must provide, through the openings on the cable restraint to hold
the power cables in place.
9. Replace the clear plastic cover over the terminal studs on the faceplate.
10. Verify that the power cables are connected correctly, that they are not touching or blocking access to
router components, and that they do not drape where people could trip on them.
11. Repeat Steps 3 through
Figure 75: Connecting DC Power to the Router
Powering On a DC-Powered MX480 Router with Normal Capacity Power
Supplies
To power on a DC-powered router:
1. Verify that an external management device is connected to one of the Routing Engine ports (CONSOLE,
AUX, or ETHERNET).
2. Turn on the power to the external management device.
10 for the remaining power supplies.
259