Ac Power Circuit Breaker Requirements For The Mx480 Router; Ac Power Cord Specifications For The Mx480 Router - Juniper MX480 Hardware Manual

Calculating Power Requirements for MX480 Routers | 199

AC Power Circuit Breaker Requirements for the MX480 Router

Each AC power supply has a single AC appliance inlet located on the power supply that requires a dedicated
AC power feed. We recommend that you use a customer site circuit breaker rated for 15 A (250 VAC)
minimum for each AC power supply, or as required by local code. Doing so enables you to operate the
router in any configuration without upgrading the power infrastructure.

AC Power Cord Specifications for the MX480 Router

Each AC power supply has a single AC appliance inlet located on the power supply that requires a dedicated
AC power feed. Most sites distribute power through a main conduit that leads to frame-mounted power
distribution panels, one of which can be located at the top of the rack that houses the router. An AC power
cord connects each power supply to the power distribution panel.
You can order detachable AC power cords, each approximately 8 ft (2.5 m) long that supply AC power to
the router. The C19 appliance coupler at the female end of the cord inserts into the AC appliance inlet
coupler, type C20 (right angle) as described by International Electrotechnical Commission (IEC) standard
60320. The plug at the male end of the power cord fits into the power source receptacle that is standard
for your geographical location.
Table 16 on page 51 provides specifications and
cord provided for each country or region.
Table 16: AC Power Cord Specifications
Country
Australia
China
Europe (except Denmark, Italy,
Switzerland, and United Kingdom)
Italy
Figure 13 on page 52
Model Number
CBL-M-PWR-RA-AU
CBL-M-PWR-RA-CH
CBL-M-PWR-RA-EU
CBL-M-PWR-RA-IT
depicts the plug on the AC power
Electrical
Specification Plug Type
240 VAC, 50 Hz AC SAA/3/15
220 VAC, 50 Hz AC CH2-16P
220 or 230 VAC, 50 CEE 7/7
Hz AC
230 VAC, 50 Hz AC CEI 23-16/VII
51