Replacing The Management Ethernet Cable On An Mx Series Router - Juniper MX480 Hardware Manual

Replacing the Management Ethernet Cable on an MX Series Router

One Ethernet cable with RJ-45 connectors is provided with the router. To replace the cable connected to
the ETHERNET port:
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Press the tab on the connector, and pull the connector straight out of the port.
shows the connector.
3. Disconnect the cable from the network device.
4. Plug one end of the replacement cable into the ETHERNET port.
5. Plug the other end of the cable into the network device.
Figure 90: Cable Connector
Figure 91: Ethernet Port
SEE ALSO
Replacing an MX960 Routing Engine
Figure 90 on page 287
Figure 91 on page 287 shows the port.
287