Juniper MX480 Hardware Manual page 331

user@host>request chassis fpc slot slot-number offline
For more information about the command, see the
To take a PIC offline:
Press the online/offline button on the PIC. For a PIC installed in an FPC3, use a narrow-ended tool
that fits inside the opening that leads to the button. Press and hold the button until the PIC LED
goes off (about 5 seconds).
Issue the following CLI command:
user@host> request chassis pic fpc-slot fpc-slot pic-slot pic-slot offline
For more information about the command, see the
To take a MIC offline:
Press the online/offline button on the MIC. Use a narrow-ended tool that fits inside the opening
that leads to the button. Press and hold the button until the MIC LED goes off (about 5 seconds).
Issue the following CLI command:
user@host> request chassis mic fpc-slot mpc-slot pic-slot mic-slot offline
For more information about the command, see the
3. Disconnect the cable from the cable connector port. If the component uses fiber-optic cable, immediately
cover each transceiver and the end of each cable with a rubber safety cap.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
CAUTION:
are inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Remove the cable from the cable management brackets.
5. Disconnect the cable from the destination port.
Do not look directly into a fiber-optic transceiver or into the ends
Do not leave a fiber-optic transceiver uncovered except when you
CLI Explorer.
CLI Explorer.
CLI Explorer.
335