Troubleshooting The Mx480 Mics - Juniper MX480 Hardware Manual

For further description of the output from the commands, see the Junos OS Administration Library.
SEE ALSO
MX480 Flexible PIC Concentrator (FPC) LEDs | 121
Replacing an MX480 FPC | 345
Holding an MX480 FPC | 340
Storing an MX480 FPC | 344
Maintaining MX480 FPCs | 338

Troubleshooting the MX480 MICs

Problem
Description: The MICs are not functioning normally.
Solution
Check the status of each port on a MIC by looking at the LED located on the MIC faceplate. For
information about the meaning of LED states on different MICs, see the
Reference.
Check the status of a MIC by issuing the show chassis fpc pic-status CLI command. The MIC slots in
the MPC are labeled PIC 0/1 and PIC 2/3, left to right:
user@host> show chassis fpc pic-status
Slot 0 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 1 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 2 Online
PIC 0 Online
PIC 1 Online
Slot 3 Online
PIC 0 Online
DPCE 4x 10GE R EQ
1x 10GE(LAN/WAN) EQ
1x 10GE(LAN/WAN) EQ
1x 10GE(LAN/WAN) EQ
1x 10GE(LAN/WAN) EQ
DPCE 40x 1GE R EQ
10x 1GE(LAN) EQ
10x 1GE(LAN) EQ
10x 1GE(LAN) EQ
10x 1GE(LAN) EQ
MS-DPC
MS-DPC PIC
MS-DPC PIC
MPC Type 2 3D EQ
1x 10GE XFP
MX Series Interface Module
443