Juniper MX480 Hardware Manual page 350

CAUTION:
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
7. On the MPC, pull the ejector lever that is adjacent to the MIC you are removing away from the MPC
faceplate. Pulling the ejector lever disconnects the MIC from the MPC.
NOTE: To remove a dual-wide MIC that takes up both MIC slots, you must pull both
ejector levers away from the MPC faceplate.
8. Grasp the handles on the MIC faceplate, and slide the MIC out of the MPC card carrier. Place it in the
electrostatic bag or on the antistatic mat.
9. If you are not reinstalling a MIC into the emptied MIC slot within a short time, install a blank MIC panel
over the slot to maintain proper airflow in the MPC card cage.
Figure 123: Removing a MIC
Figure 124: Removing a Dual-Wide MIC
Ejectors
MIC handles
Avoid bending a fiber-optic cable beyond its minimum bend radius.
354