Table of Contents
Advertisement
Handling Messages and Error Messages
A Message Appears
These are the main messages that appear on the machine's display to prompt correct operation. They
do not indicate any errors. Follow the prompts and take action accordingly.
[ 1
2 ■ 3 ■ 4 ■ 5 ■ 6 ■ ]
Only a small amount of ink remains. Replace the ink cartridge indicated by the flashing number with a new
cartridge.
[PRESS THE POWER KEY TO CLEAN]
This message appears when the machine has been unused for about one month. Turn on the sub power once
a month.
P. 50, "Introduction: About Maintenance"
[CIRCULATING INK]
White ink is being circulated inside the machine. This action is automatically performed to clear the white ink
precipitation. Wait until the displayed message changes.
[SET CARTRIDGE]
Insert the ink cartridge indicated by the flashing number. These messages appear during ink cartridge replace-
ment and in similar situations.
[REMOVE CARTRIDGE]
Remove the ink cartridge indicated by the flashing number. These messages appear during ink cartridge
replacement and in similar situations.
[SET CL-LIQUID]
Insert the SOL INK cleaning cartridge into the slot(s) indicated by the flashing number. This message appears
at times such as during head cleaning.
[REMOVE CL-LIQUID]
Remove the SOL INK cleaning cartridge indicated by the flashing number. This message appears at times such
as during head cleaning.
[CLOSE THE COVER (FRONT COVER or PANEL COVER) DRY-UP MAY DAMAGE THE
HEAD]
Close either the front cover and panel cover, or both. If the message is left displayed, the print heads may dry
out, resulting in malfunction.
[SETUP MEDIA]
Reload the media and press [SETUP]. This message appears when an attempt to perform a printing test was
made while no media was loaded.
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain bottle, and then press [ENTER].
83
Chapter 4 Appendix
Advertisement
Table of Contents
