Error & Status Messages on the Display
This section explains what the messages that appear on the display mean and what to do when a
particular message appears.
Status Messages
Message
Loading Ink... / WAIT! N minutes
Maintenance in process...
Press Start key
Processing...
Ready
Resetting Job...
Setting change...
Waiting...
Error Messages
Message
Adjust height, press Start to /
restart or Tray to reset garment
Adjust height, press Start to /
restart or Tray to reset garment
Auto Head Maint.
Required.
Ink being filled.
"N" indicates time required for this operation.
The machine is cleaning or flushing its print head. Wait a moment.
Printing data was received. Press the [Start] key and start printing.
The machine is printing.
The machine is able to print.
The machine is reinitializing a print job. Wait a moment. If the
message does not disappear after a while, turn off the machine, and
then turn it back on.
The machine is updating the network interface. Wait a moment.
Wait a moment.
Causes
Wrinkles, slacks or floats remain
on the fabric or the edges of the
fabric are protruding from the
tray.
Fabric that is 4 mm (about 0.2
inches) or thicker is loaded on
the A4 standard tray or A5 tray.
Regular maintenance is needed.
Usually it is displayed once every
one or two weeks. Even if the
frequency of use is low, it is
always displayed once every four
weeks.
Error & Status Messages on the Display
Status
Solutions
Detach the tray, and then load
the fabric again.
If the message reappears, adjust
the height of the tray manually.
See page 188 "The Tray Does Not
Operate Correctly ".
Load fabric that is up to 4 mm
(about 0.2 inches) thick on the A4
standard tray or A5 tray.
Clean the print head nozzles.
203