Correcting Misalignment For Printing And Cutting When Using Crop Marks - Roland LEC-300A User Manual

5-7 Performing Printing and Cutting Separately
2.
Set the align points.

Use
tion shown in the figure.

SETTING
ALIGN POINT 1

This indicates that the base point
and align point 1 have been set.
 Repeat steps

Send the cutting data and perform cutting.
About Align Points
The numbers for align points are determined with reference to the location of the base point. You can-
not set an align point unless you specify a base point. Redoing the setting for the base point clears any
align points that have been set.

Correcting Misalignment for Printing and Cutting When Using Crop Marks

Procedure
1.
Check the setting for the [AUTO ENV. MATCH] menu item.
Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
 P. 102, "Executing Environment Matching Automatically"
126
Chapter 5 Feature Reference
Hold down
The number of the align point you set is automatically deter-
mined.
Press
 
through to specify other align points as required.
to align the center of the blade with the loca-
for one second or longer.
.