Correcting The Misalignment Of Printing And Cutting With Crop Marks (Separate Test For Printing/Cutting With Crop Marks); Correcting The Misalignment Of Printing And Cutting With Crop Marks; Ing/Cutting With Crop Marks) - Roland VersaUV LEC2-300 User Manual

Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for
Printing/Cutting with Crop Marks)
Due to changes in the thickness of media caused by laminating and misalignment of the loading position of the
media before and after cutting, the positioning of printing and cutting may be misaligned even when you are using
crop marks. Make corrections for misaligned printing and cutting for the media you are using and its condition.
In this test, so as to create the same conditions as the actual operation, print only the crop marks, remove the
media, load the media again, and then cut the media.
1.
Adjust the misalignment of the ink landing position.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
MEDIA GAP ADJ.
3.
Press [▶] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
4.
Press [ENTER].
Printing of the test pattern starts.
5.
When printing is finished, press [▼], then [▶] to display the screen shown below.
SIMPLE SETTING
0
6.
View the printed test pattern, and then determine the correction value.
Select the value that gives the least misalignment between the two lines. In the case of the following figure,
select "-3." When you cannot choose between two sequential numbers, select a value that is between them
(you can set correction values in units of "0.5").
7.
Press [▲] or [▼] to select the correction value.
8.
Press [ENTER] to confirm your entry.
9.
Press [◀] or [▲] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
10.
Press [ENTER].
Printing of the test pattern starts.
Accurately Adjusting the Settings for Cutting with Crop Marks
0
1. Optimizing the Output Quality
151