Using Transparent Media - Roland TrueVIS VF2-640 User Manual

Configuring Settings to Match the Properties of the Media

Using Transparent Media

You can even set up transparent media by setting "SHEET TYPE" to "CLEAR" and manually setting the media width
and the loading position.
Normally, detecting the leading and trailing edges of the media enables you to verify the presence of the media,
and the media is then ready for setup. However, since transparent media cannot be detected, setup will not be
possible.
1.
Set the media type to "CLEAR".
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
SUB MENU
3.
Press [▶] to display the screen shown below.
SUB MENU
SHEET TYPE
4.
Press [▶] to display the screen shown below.
SHEET TYPE
OPAQUE
5.
Press [▲] or [▼] to select "CLEAR".
SHEET TYPE
OPAQUE
6.
Press [ENTER] to confirm your entry.
MEMO
• Default setting: "OPAQUE"
• When set to "CLEAR", printing operation does not stop when the media runs out. If media runs out while printing is in
progress, immediately press [PAUSE] to stop printing. Otherwise, there is a chance that the platen or other parts may
become soiled by ink or that ink may get inside and damage the machine.
2.
Set the media width.
Procedure
1.
Press [◀], then [▼] to display the screen shown below.
SUB MENU
SHEET WIDTH
2.
Press [▶] to display the screen shown below.
SHEET WIDTH
1625mm
3.
Press [▲] or [▼] to enter the width of the media.
4.
Press [ENTER].
76
1. Optimizing the Output Quality
OPAQUE
CLEAR
1625mm