Installing An Sfp Or Xfp Transceiver Into An Mx2020 Mpc Or Mic - Juniper MX2020 Hardware Manual

CAUTION:
before reinserting it or inserting a transceiver into a different slot.
SEE ALSO

Installing an SFP or XFP Transceiver into an MX2020 MPC or MIC | 567

Installing an SFP or XFP Transceiver into an MX2020 MPC or MIC
To install an SFP or XFP:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Take each transceiver to be installed out of its electrostatic bag, and identify the slot on the component
where it will be installed.
3. Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the transceiver with a
safety cap.
4. Carefully align the transceiver with the slots in the component. The connectors should face the
component.
5. Slide the transceiver until the connector is seated in the component slot. If you are unable to fully insert
the transceiver, make sure the connector is facing the right way.
6. Close the ejector handle of the transceiver.
7. Remove the rubber safety cap from the transceiver and the end of the cable. Insert the cable into the
transceiver.
After removing a transceiver from the chassis, wait at least 30 seconds
567