Installing Smartpac 2 Enclosure - Honeywell SmartPAC 2 User Manual

1126800

Installing SmartPAC 2 Enclosure

NOTICE
If your SmartPAC 2 is a panel mount version, go to page 72 for mounting instructions.
NOTICE
PLACE SMARTPAC 2 AT A CONVENIENT HEIGHT
SmartPAC 2 should be installed at a convenient height for all users. An ideal height is to
have the top edge of the unit approximately at chin level. Experiment to determine a good
height for everybody before mounting.
To mount the enclosure, follow the steps below.
1. Determine a convenient place for the control enclosure. Ideally it should be close to
where operators and setup personnel can easily see the readouts and reach the keyboard.
Make sure all cables will reach. Leave enough room to open the door at least 120°. The
enclosure can be mounted on a pedestal, pendant, or on the press itself. SmartPAC 2 is
also available for panel mounting.
2. Drill holes for mounting, according to the figure below. Shockmount studs are ¼–20. Tap
holes (if necessary) and mount the enclosure using the enclosed shock mounts. Use a No. 7
drill and ¼–20 tap.
Go to "Wiring Between WPC and SmartPAC 2," page 74, to start wiring your SmartPAC 2.
Page 70
SmartPAC 2 with WPC Integration
Chapter 2 Installing SmartPAC 2 and WPC