Honeywell SmartPAC 2 User Manual page 121

SmartPAC 2 with WPC Integration
2. On the SmartPAC 2 PC board, locate the LEDs labeled "Tx6" and "Rx6" near TB105
(see Figure A at the end of the manual).
• If both Tx6 and Rx6 blink, the SmartPAC 2 and WPC are communicating. Check the
initialization menu again.
• If "PRESS CONTROL" appears on the menu, go to the next section and continue to
set up your system.
• If "PRESS CONTROL" still does not appear there, contact Wintriss Tech
Support.
• If the green Rx6 does not blink, power down SmartPAC 2 and WPC. Recheck the
communications wiring. Refer to "Wiring between WPC and SmartPAC 2," page 74.
Power up both units and go to the SmartPAC 2 Main Initialization menu.
• If "PRESS CONTROL" appears, go to the next section and continue to set up
your system.
• If "PRESS CONTROL" still does not appear there, contact Wintriss Tech
Support.
Installing SmartPAC 2 and WPC Chapter 2
1126800
page 99