How To Terminate Cable Shields - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
Figure 2 - 2. Attaching Wires to Connector

How to Terminate Cable Shields

NOTICE
TERMINATE BOTH ENDS OF SHIELD
Be sure to terminate the cable shields at both ends (for example, at SmartPAC 2 and DSI 2).
Your Wintriss units have ground studs on the inside of the enclosure for terminating cable
shields at the point of entry.
Drain wire
Secure drain wire
under nut on
ground stud
Figure 2 - 3. Connecting Shield Drain Wire to Ground Stud
For each shielded cable, perform the following steps. Refer to the figure above.
1. Strip the cable jacket as far as the end of the conduit fitting.
2. Cut the drain wire to a length that can wrap at least once around the nearest ground stud.
Loosen the nut on the stud, wrap the drain wire around clockwise and tighten the nut.
3. Connect the rest of the wires in the cable to the terminal block as appropriate.
Installing SmartPAC 2 and WPC
tighten screw to clamp
wire in terminal
insert wire here
Chapter 2
1126800
Strip cable jacket
as far as end of
conduit fitting
page 31