Figure 5 - 32. One On/Off Arc - Honeywell SmartPAC 2 User Manual

1126800
Setting Multiple ON/OFFs
NOTICE
A new arc always starts at 0 ° . Move each arc to the correct location before adding another
arc. If one of the arcs will stay near 0 ° , program it last. If you find you have too many arcs at
0 ° , delete the channel settings (page 313) and start over again.
1. Set the first ON/OFF arc as described above, "Make an ON/OFF Setting for a Channel,"
page 305. The display looks something like the following figure.
2. Add another arc by pressing F6-"Add a New Arc." The arc you already set turns dark
gray. A new arc appears as a green line at the zero (0) position.
3. Use the cursor keys to place the arc where you want it.
page 308

Figure 5 - 32. One ON/OFF Arc

Figure 5 - 33. Add a New Arc
Chapter 5
SmartPAC 2 with WPC Integration
F1
F2
F3
F4
F5
F6
F7
F8
F1
F2
F3
F4
F5
F6
F7
F8
SmartPAC 2 Program Mode