Two-Hand Operation, Single Stroke Mode - Honeywell SmartPAC 2 User Manual

1126800

Two-hand Operation, Single Stroke Mode

! DANGER
operator station wired incorrectly
Run all necessary tests to verify that each operator station is wired correctly and provides
proper anti-tie-down and anti-repeat protection.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
MORE OPERATORS THAN OPERATOR STATIONS
• Ensure that there are the same number of active operator stations as there are operators, if
the press is not equipped with properly installed and operating light curtains.
• During setup, lockout/tagout the press if there are more operators than operator stations.
• Verify at every shift change that there are the same number of active operator stations as
there are operators, if the press is not equipped with properly installed and operating light
curtains.
Failure to comply with these instructions will result in death or serious injury.
! DANGER
Two-hand control too close to hazardous area
Verify at each shift change that any moveable two-hand controls are located at least the
safety distance away from the pinch point or hazardous area.
Failure to comply with these instructions will result in death or serious injury.
! DANGER
IMPROPER SAFEGUARDING
Ensure that the machine guarding system is installed and maintained according to OSHA
standard 1910.217, ANSI B11.1, ANSI B11.19 and any other regulations and standards that
apply. Ensure that guarding is properly installed to prevent access to the machine over,
under or around any guarding device.
Failure to comply with these instructions will result in death or serious injury.
1. Select TWO HAND the mode select menu (page 365).
2. Turn the stroke select key to Single Stroke.
3. To initiate a stroke, press both the RUN/INCH buttons.
• If you have one operator station, both run buttons (switches) must be depressed
within 0.5 seconds of each other.
Page 370
SmartPAC 2 with WPC Integration
Chapter 6 SmartPAC 2 Run Mode