Light Curtain Break" Mode - Honeywell SmartPAC 2 User Manual

1126800
Figure 2 - 13. One-hand Control Switch Base, Showing Mounting Holes
Figure 2 - 14. Wiring Connections in One-hand Control Switch

"Light Curtain Break" Mode

You can use One-hand Control in "light curtain break" mode. In this mode, you must push
the button on One-hand Control within eight seconds after removing your hands from the
light curtain. Otherwise, the press will not cycle. This mode prevents inadvertent operation
when an operator is loading or unloading parts. If this mode is not used, One-hand Control
cycles the press in single stroke mode whenever you push the button on the One-hand
Control.
Page 60
Install with 10-32 screws, 4 places
3.25
(82.6)
Dimensions: inch
mm
Connections diagram on this surface
12
14
(Switch Cover, Bottom View)
Chapter 2
SmartPAC 2 with WPC Integration
4.00
(101.6)
2.69
(68.3)
3.88
(98.6)
11
13
Installing SmartPAC 2 and WPC