Installation; Installing The Compact Enclosure Panel; Installing On A Wall - Honeywell NetAXS-123 Installation Manual

3.0 Installation

3.1 Installing the Compact Enclosure Panel

Perform the following steps to install the NetAXS-123 Compact panel:

3.1.1 Installing on a Wall

1. Review the panel layout, cable runs, and power needs.
2. Mount the enclosure's back at the proper location on the wall:
NetAXS-123 Access Control Unit Installation Guide, Document 800-05779, Revision A
Use a static strap whenever touching the panel to ensure protection from Electrostatic
Warning:
Discharge (ESD).
a. Drill the screw holes in the wall, using the panel's back as a template, and then pull the
power and all I/O wires to the enclosure and through the knockout holes, and properly
mark each wire for its use.
b. Screw the back of the panel to the wall, using either drywall screws or threaded wall
anchors.
Installing the NetAXS-123 Panels
Installation
11