Honeywell SmartPAC 2 User Manual page 155

SmartPAC 2 with WPC Integration
7. Power down the press and press control. Replace the fuse you removed in step 5.
8. Power up the press and press control. Make sure the press is still in Inch mode. Push the
RUN/INCH buttons briefly. The ram should move.
• If the ram moves, go on to the next test.
• If the ram does not move, check the wiring and correct any problems. Power up the
press and control. Push the RUN/INCH buttons again. If the ram still does not move,
contact Wintriss Tech Support.
Installing SmartPAC 2 and WPC Chapter 2
1126800
page 133